First commit

2026-07-23 00:33:55 +00:00
parent 8213b0aee3
commit 7d31ca5d65
14 changed files with 1233 additions and 4 deletions
@@ -443,6 +443,52 @@ free -h
 - Check Nginx WebSocket proxy config: `/etc/nginx/sites-available/archipelago` must include `proxy_set_header Upgrade $http_upgrade`
 - If on WiFi, try wired Ethernet for more stable connectivity

+### 21. LoRa radio firmware flash failed / board unresponsive
+
+**Symptoms**: The "Erase & Flash Now" flow in the mesh hot-swap modal reports
+an error, or the radio no longer enumerates as a serial device after a flash
+attempt.
+
+**Diagnosis**:
+```bash
+# Poll the flash job's last-known stage/error directly
+curl -s http://localhost:5678/rpc/v1 \
+  -H 'Content-Type: application/json' \
+  -d '{"method":"mesh.flash-status","params":{}}'
+
+# Confirm the board is still enumerating at all
+ls -la /dev/ttyUSB* /dev/ttyACM* /dev/mesh-radio 2>&1
+
+# esptool/rnodeconf binaries present?
+which esptool; ls -la /usr/local/bin/archy-rnodeconf
+```
+
+**Solutions**:
+- A failure during `erasing`/`writing` (MeshCore/Meshtastic) or
+  `autoinstalling` (Reticulum) can leave the chip erased or half-written —
+  this is expected risk of the "always erase first" default, not a bug.
+- Heltec V3/V4 boards can be forced back into bootloader mode manually: hold
+  **BOOT**, tap **RST**, then release **BOOT** — this puts the chip in a
+  state esptool can always talk to, regardless of what firmware (if any) is
+  currently on it.
+- With the board in bootloader mode, a manual recovery flash can be run
+  directly over SSH without the UI:
+  ```bash
+  esptool --chip esp32s3 --port /dev/ttyACM0 erase_flash
+  esptool --chip esp32s3 --port /dev/ttyACM0 write_flash 0x0 <known-good-image.bin>
+  ```
+- For Reticulum/RNode boards, the equivalent manual recovery is
+  `archy-rnodeconf /dev/ttyACM0 --autoinstall` (or `/usr/local/bin/archy-rnodeconf`
+  if it's not on `PATH`) — it re-runs the same fetch+erase+flash+bootstrap
+  sequence the UI triggers.
+- If `esptool`/`archy-rnodeconf` are missing entirely, they should have been
+  installed by the last `self-update.sh` run — check
+  `sudo journalctl -u archipelago-update` for install failures, or install
+  `esptool` via `sudo apt-get install esptool` directly.
+- Once a fresh image is confirmed written, unplug/replug the radio (or wait
+  for the next detection poll) — the hot-swap modal re-probes automatically
+  and shows whatever firmware is actually on the board now.
+
 ---

 ## General Maintenance