Plugging in any LoRa radio now surfaces the device setup modal EVERY time
(dismissals clear on unplug; works while mesh is enabled; 2-poll debounce
so ordinary reconnect blips don't flash it), showing what's currently on
the stick before anything is written:
- mesh.probe-device RPC: identifies the firmware read-only in the same
Reticulum->Meshcore->Meshtastic order as auto-detect. Meshtastic yields
region/modem-preset/channels (want_config is a read); MeshCore yields
name/node-id + firmware version via the previously-unused
CMD_DEVICE_QUERY; RNode via the bare KISS DETECT (no daemon spawn).
Path must be a detected candidate port; the live session's port refuses.
- "Keep As Is": manage_radio=false persists in MeshConfig and the session
skips every on-connect config write (region, channel, PHY params, advert
name) — the radio runs exactly as flashed, hot-swappable.
- "Set Up with Archipelago Settings": second screen shows the params that
will be applied (channel, region, the node's persisted RF params - e.g.
the validated Portugal preset - with the per-region community plan as
fallback) before writing anything.
- Stale-type fix: disconnect now resets device_type/firmware_version, so
a swapped stick no longer shows the previous radio's firmware; probed
kind pins device_kind so the right probe runs first on connect.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Plugging in a LoRa radio now pops a global two-step setup modal on any
page: step 1 shows the ACTUAL detected board (25 board SVGs vendored
from the Meshtastic web-flasher, GPL-3.0; matched by USB product string
on native-USB boards, vid:pid heuristics for bridge chips, animated
fallback otherwise); step 2 configures with Archipelago presets — the
LoRa region pre-selected from the node's location (new lat/lon→region
mapping), channel 'archipelago', node name, and an advanced firmware
pin. Options adapt per protocol: region+channel program Meshtastic;
MeshCore shows its community frequency plan (firmware owns RF); RNode
defers to the Reticulum daemon config.
Backend: mesh.configure now accepts lora_region (validated against the
driver's region table) and device_kind (probe pin); mesh.status returns
the persisted values plus per-port USB identity (sysfs vid/pid/product)
for board identification. The Mesh Device tab gains a full settings
form (region with duty-cycle/legality hints, firmware pin, channel,
name, identity broadcast) replacing the read-only panel; the old
Mesh-page-only onboarding modal is superseded by the global flow.
Mock backend: stateful mesh config so the dev UI demos the full
detect→configure round-trip (disable mesh → modal fires with Heltec V3).
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
